Use 1" fender washer and 1 1/2" wood screws to attach to dash board. Once you get the the HUD bezel to fit, then Attach magnets to BEZEL in appropriate places to hold down the bezel through out. ALso quite a bit of sanding and molding with epoxy will be required We used a combination of clear and black (bumper) repair epoxysĪlso you may need to heat and mold the cut off section to match curvatures. Use part of the remaining non hud bezel to make a support for the joint you cut. Once the bezel is molded for the dash curve, cut about 4 inches from left side and 4 1/2 inches from non hud bezel. Its best if you have a spare junk dash to use as template. ALso the bezel will need to be heated patiently over and over and molded to curve of dash.
These will need to be cut on the left side in order to fit the slight angle differences between cutlass and GP. I wanted black buttons, so i also took the switches completely apart and painted the rubber portions of the buttons. Unless you are ok with GP grey color, then no work required. There are 4 small screws that hold the light switch to the bezel, the faceplate had to be removed. This requires completely removing and disassembling both light switches. I had overlays made to match my speedometer. Since Cutlass doesn't have hud switch, you will need to use GP HUD Switch. ALso the dash has the square holes for clip nut, same clip nut used for radios, good to grab from junkyard. **Side note, you will have to take the top half off of the HUD to fit, due to clearance, then once installed you will need to reinstall screws for top side of HUD. Once cut out with dremel, careful not to knick the windshield.you may test fit HUD and trim extra to fit harness of the left side. Also note that under the dash already has supports built into it for a HUD.
There is a notch on the front dash that we measured from. Remove cluster and components, as it makes it easier to access dash for cutting. Notice the light switch and extra harness located behind. The Harnesses already have the pigtails and operational.
here is the write up for installing HUD on memphisman and pshojo 95 Vert HUD.įirst start with LQ1 vehicle, i do not believe the 3.1L cutlasses have pigtails in harness as our Vert LQ1 did.
0 kommentar(er)
